Elbow universal RTP

Соответствует BIM-стандарту 2.0


ELBOW (universal) “RTP” D110 mm-used in internal sewage systems. Universal Elbow “RTP” D110 mm is used in the case when a non-standard angle of inclination of the pipeline is necessary, or when there is no possibility to determine the slope for the disposal of the riser. Universal Elbow allows you to adjust the angle and connect the two sections of the pipe together without the use of additional fittings. Due to the special movability, the Universal Elbow can be used when installing toilets with direct, horizontal or vertical release. M. O. L. rings are used as a seal. M. O. L. rings of the European manufacturer are made of a special soft rubber compound for smoothing small irregularities and roughness of the pipe. The main advantages of the universal Elbow “RTP”: • Speed and ease of installation • Save time and money • Environmentally friendly material • Increased chemical resistance • Upper temperature limit +95°C • Tightness of joints • Service life-at least 50 years MOL get flexibility Our motto ‘get flexibility’ is not only about flexible products, but also is an expression of mutual development together with the customer that leads to a successful and sustainable partnership that results from flexibility and commitment. A long-term experience and monitored quality systems (including DIN ISO 9001:2008) guarantee the highest possible safety and reliability


LLC “RTP” was founded in Y2005 as a manufacturer of plastic pipes and fittings according to the demands of the Russian and foreign markets. The plant is located in the Moscow region, Yegoryev district, vil. Lelechi, 47, where the first shop was built in Y20015 and the modern European equipment for production of the plastic pipes and fittings were installed.

All technical staff of LLC “RTP” completed preparation courses and tutorials in the European plants of equipment suppliers and obtained the applicable quality certificates. The foreign specialists were invited to perform such works as well. We use the best raw materials, meet the highest standards of production and perform product quality control.


When placed in a project, the family fills in the specifications. The family uses common parameters in accordance with the Autodesk BIM 2.0 standard.



To use the program you must first install Autodesk Revit application.


To use the family in the project, you must extract the files with extension rfa from archive and save to computer.


  • After the installation procedure, run the Autodesk Revit;
  • Go to tab Insert;
  • Next, using the command Load Family, specify the family file unpacked from the archive;
  • Position the family in the project.

Download info

Do you want to publish
your BIM content?